Lan And Wan Port Addresses; Reset Of Webshare Wireless Router Adsl2; Informations From The Isp - Atlantis Land A02-RA141-W54 User Manual

3.2.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default
values are shown below.
Porta LAN
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs

3.3 Reset of WebShare Wireless Router ADSL2+

If you forget the password, you can restore router with Default Factory Setting
using "Reset" button in the rear of the product. To do this operation is necessary
be sure that led SYS is lit, then press "Reset" button for 10 seconds. The LED
SYS will turn off and it will blink; it will be lit when firmware with Factory Default
Setting will be loaded. Now you can enter on WebShare Wireless Router ADSL2+
with password "atlantis".

3.4 Informations from the ISP

Before configuring this device, you have to check with your ISP (Internet Service
Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or
IPoA.
Gather the information as illustrated in the following table and keep it for
reference.
VPI/VCI,
Password, Service Name, and Domain Name System (DNS)
PPPoE
IP address (it can be automatically assigned by your ISP when
you connect or be set manually).
VPI/VCI,
Password, and Domain Name System (DNS) IP address (it
PPPoA
can be automatically assigned by your ISP when you connect
or be set manually).
VPI/VCI, VC-based/LLC-based multiplexing to use Bridged
RFC1483
Mode.
Bridged
VPI/VCI, VC-based/LLC-based multiplexing, IP address,
RFC1483
Subnet mask, Gateway address, and Domain Name System
Routed
(DNS) IP address (it is fixed IP address).
192.168.1.254
255.255.255.0
Enabled
100 IP addresses
continuing from
192.168.1.100 through
192.168.1.199
VC-based/LLC-based
VC-based/LLC-based
A02-RA141-W54
WebShare 141W
Porta WAN
Mode=Routing
Encapsulation=PPPoA
Multiplex=VC
VPI=8
VCI=35
multiplexing, Username,
multiplexing, Username,
Pag. 20