Table of Contents
Advertisement
SENTINEL MODE IS DEACTIVATED WHEN:
¾ Key is turned to "ON" position.
¾ Main switch is no longer in "LOW TEMP" position.
¾ One of safety devices, with exception of applying brakes or sending a remote control
command (see "What will stop your engine" below), detects an infringement of safety
conditions.
UPON ENTERING YOUR VEHICLE ...
¾ Do not apply brakes; this will turn off engine immediately. U
¾ Insert ignition key and turn it to "ON" position.
WARNING:
¾ Drive as usual.
U Remember that engine will also stop if hand brake is released or gearshift is moved
before turning key to "ON" position.
WHAT WILL STOP YOUR ENGINE
For your safety, engine will not start or will stop if:
¾ Remote control sends a stop message.
¾ Hood is open.
¾ Brakes are applied.
¾ Gearshift is not in "NEUTRAL".
¾ Hand brake is not ON properly.
¾ Engine exceeds 3000 rpm.
¾ Main switch is OFF.
ENGINE RUNTIME
Your engine will stop automatically after a preset time. Parking lights will stay on as long
as engine is running. Runtime is programmable during installation. Manufacturer preset
time is 15 minutes but you can have it changed to suit your needs.
IF ENGINE FAILS TO START
If your system cannot start your vehicle at first attempt, it will wait a few seconds and
then try again (it could try again twice depending on reason for failure to start), after
which it will shut down automatically and wait for new command.
DO NOT TURN IGNITION KEY TO "START" POSITION.
5
Advertisement
Table of Contents
