Table of Contents
Advertisement
Quick Links
Ⅰ.SAFE DRIVE
Rules for Safe Drive
Check must be conducted,bef ore starting the engine,to prevent mishaps and damage to componen ts.
Only the qualified person who has passed the drive examination with a drive license is permitted to drive the
vehicle but not anybody else without a drive license.
Full preoccupation is required during drive, paying attention to the follow ing points to avoid any possible
hurt to you by other motor ized vehicles:
Do not drive too close to other vehicles;
Never contend for lane.
Strictly observe the local traffic rules.
As driving at overspeed is the cause of many accidents. Do not drive at a speed that the actual situation does
not permit.
Particular care should be exercised at the level crossing of roads, entrance and exit of parking lot or on the
automobile lane.
During drive, grasp the left handlebar by the left hand and the throttle twist grip by the right hand,with feet
on the footrests.
1
Advertisement
Table of Contents
Related Manuals for Kinroad XT110-9
Summary of Contents for Kinroad XT110-9
-
Page 1: Safe Drive
Ⅰ.SAFE DRIVE Rules for Safe Drive Check must be conducted,bef ore starting the engine,to prevent mishaps and damage to componen ts. Only the qualified person who has passed the drive examination with a drive license is permitted to drive the vehicle but not anybody else without a drive license. - Page 2 Protective wear 1.Protective wear such as helmet with protective mask, dustproof glasses and gloves should be worn during drive for the sake of personal safety. 2.Loose clothes are not suitable for motorcycle drive or ride as they may get caught on the operating lever ,kick ,footrest or wheel, resulting in danger.
- Page 3 Ⅱ.MAIN DATA Overall length 1975mm Cylinder bore x stroke 52.4×50.0 Overall width 710mm Compression ratio 9.1:1 1090mm 5.0kw/8000r/min Overall height Output,max Wheelbase 1240mm Torque,max 6.8N.m/5000r/min Dead weight 101kg Idling speed 1500r/min±100r/min 104kg 108ml Payload Displacement of cylinder Front wheel 2.50-17 Spark plug A7RTC Rear wheel...
-
Page 4: Parts & Subassemblies
III.PARTS & SUBASSEMBLIES... -
Page 7: Operation
IV.OPERATION only be used when the normal supply is run out,) In this case,refueling should be carried out as soon as possible; for there is only Fuel Cock somel.0L of fuel reserve for use. 1.Fuel filling The capacity of the fuel tank is 4.5L.Leadless gasoline of No.90or above or low-lead gasoline is required for the motorcycle.To fuel the vehicle,support it by the main stand, open the lock cover of the fuel tank and fill fuel through the... -
Page 8: Engine Starting
Engine Starting 5.Turn the carburetor choke bar downward Warning:Never start the engine in a closed to fully open the choke when the engine is place or warehouse or warehouse as the sufficiently warmed up. exhausted gas from the vehicle contains toxic ★Caution: carbon monoxide. - Page 9 Electric start button The electric start button is located below the right handlebar.When the ignition switch is set in “ON” position and the engine is in the neutral position , push the button to start the engine by holding the front brake or stepping on the rear brake. Otherwise,the engine can not be started.
-
Page 10: Switches On Left Handle Bar
Switches on Left Handle bar 1. Headlights dimmer button Position,Headligh is in high beam. Position, Headligt is in low beam 2. turning light switch position,Left ition,Right 3. Horn button press this button for horn... - Page 11 Gear Shifting A non-cycling mode of gear shifting is employed of this motorcycle ● The throttle must be clossed befor the gear shifting every time, Shifing the gear before closing the condition of backing it for four times. ● The speed shifting pedal must be operated suitably. ●...
- Page 12 V.Checking,Adjustm- right side. Renewal of Machine Oil ent and Maintenance Machine oil plays a very important role in the normal operation of the Machine Oil Checking engine and for this reason,it is necessary ★ The vehicle should be checked to check the motorcycle for machine oil for machine oil before drive by sup- period ically and renew the oil once porting it with the...
-
Page 13: Check-Up Of Spark Plug
Cleaning of machine oil Check-up of Spark Plug. tank 1.Drain off all the run –in machine oil from 1.Remove the cap of spark plug and screw off the oil tank. the spark plug by the plug wrench. 2.Dismount the related parts. 2.Clean the spark plug all aroud or replace it 3.Wash clean all the related parts. - Page 14 Check-up & Cleaning of Air Filter Take out the air filter and check if it is contaminated. Dismou nting: Remove the right side cover,take out the screw and disassemble the air filter. Cleaning: Wash the filter in clean washing oil and wipe it dry with dry cloth. Soak it in clean machine oil,squeeze it dry and fit it back to position.
-
Page 15: Adjustment Of Throttle Cable
Adjustment of Throttle Cable Caution: Make sure that the adjust ing nut of the throttle Do not try to cover up any trouble of other parts of the cable and locking nut work normally. carburetor by adjust ing the idling speed. In case of Check to see if the throttle twist grip is with the any abnormality with the carburetor,it has to removed required free operating movement. -
Page 16: Brake Checking
Check-up & Adjustment of Air Valve Gap Noise will stem from too big gap of the air valve. However if there is too small gap or even no gap at all, closing of the valve will be hindered, which will cause burn of the valve and output drop. Therefore, the air valve gap must be checked periodically. - Page 17 Adjustment of Front Brake worn. (1) The front brake has a free operating movement of 10-20mm as shown in the figure on the right side. (2) inspect the reseivoir capacity and refill if necessary in order to maintain proper level in the reservior.This should be the major project of your regular inspection (3) check the front brake lining for its worm...
-
Page 18: Adjustment Of Rear Brake
Adjustment Rear on the left and right sides to adjust Brake the tension of the chain and to align the marking of the chain adjuster ★ The vehicle should be supported with the engraved lines in the by the main stand for check. similar position, on both sides. - Page 19 [Greasing procedures to the driving chain] 1.Shut off the engine. 2.Add some machine oil or chain grease to the driving chain. Attention: When the rear wheel axil has moved to the back adjust ing limit, if excess loose be cause of wearing to the driving chain, please change with a new one.
-
Page 20: Vehicle Washing
Vehicle Washing Cleaning the vehicle reularly can slow down the color fading of its body and make it easier to check if there is any damage and oil leakage with if. Caution: Washing the motorcycle with over-pressurized water may cause damage to some of its components. Therefore, do not jet over-pressurized water directly on to the follow ing parts: ——Wheel hub ——... -
Page 21: Instructions For Storage
draining off fuel. Instructions for Storage For the motorcycle not to be used for a long period 3.Take out the spark plug, pour about 15-20ml of of time, for example,in wintertime,some steps should clean engine oil into the cylinder, step down the kick be taken to pervent malfunction of and damage to its lever repectitively for several, step down the kick lever componen ts which might be caused by long storage,... -
Page 22: Resumption Of Service
1.Remoe the covering and clean the vehicle. Change the lubricating oil if the vehicle has been off service for over 4 months. 2.Drain off the remaining atomized antirust oil from the fuel tank, followed by filling it with fresh gasoline therein. - Page 23 1.Remove the covering and clean the vehicle. Change the lubricating oil if the vehicle has been off service for over 4 months. 2.Charge the battery and remount it. 3.Drain off the antirust solution from the fuel tank, followed by filling fuel therein to the required level. 4.Prior to driving, test the vehicle at low speed in a safe place.
- Page 24 Frequency Odometer km (Note2) Item /frequency Items of Maintenance 1000km 4000km 8000km 12000km remak ＊ Circurt of fuel system ＊ Fuel filter ＊ Throttle operating system ＊ Choke of car buretor Air filter element NoteI Soark olug ＊ Airvalve gap Airvalve gap Engine lubricating oil R -yearly...