Function buttons
1. ON/OFF Button
Operation
starts
and stops when this button is pressed again.
2. MODE Button
Each
time
the
mode is selected in a sequence of following:
NOTE-.
Please do not select HEAT mode if the
machine you purchased is cooling only type. Heat modeis not
supported by the cooling only appliance.
3. Swing < Button
Used to stop or start horizontal louver movement or set the
desired up/down air flow direction. The louver changes 6 degree
in angle for each press. If keep pushing more than 2
seconds, the louver will swing up and down automatically.
4. Swing «» Button
Used to stop or start vertical louver movement
and set the desired left/right air flow direction.
The vertical louver changes 6 degree in angle
for each press. And indoor unit displays '
for one second. If holding down for more than
2 seconds, the vertical louver swing feature is
activated. The indoor unit displays ' IIII' ,
flashes four times, then the temperature
setting reverts back. If the swing feature is
stopped, it displays ' LC' and remains on for
3 seconds.
NOTE: For some units , the indoor units
display '
' when the swing feature is
activated, and display '
feature is stopped.
5. SLEEP/FRESH(optional) Button
Active/Disable SLEEP function. If flushing
more than 2 seconds, the ' FRESH ' function
will be activated, pushing more than 2
seconds again to disable.
NOTE: While the unit is running under SLEEP
mode, it would be cancelled if press the MODE,
FAN SPEED or ON/OFF button.
4
when
this
button
button
is
pressed,
V '
V
' when the swing
is
pressed
the
operation