Operation - Craftsman 315.DD2101 Operator's Manual

WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the bat-
tery pack from the product when assembling parts.
AUXILIARY HANDLE ASSEMBLY
See Figure 2, page i.
An auxiliary handle is packed with the drill for ease of
operation and to help prevent loss of control. The handle
can be mounted on either side for left or right hand use.
 Insert handle screw into hole located above trigger
switch and seat hex head into hole.
WARNING:
Do not allow familiarity with tools
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
 Drilling in ceramics, plastics, fiberglass, and laminates
 Drilling in metals
 Driving screws into wood and drywall with screwdriver
bits
This product will accept Craftsman
battery packs and Craftsman
tery packs.
For complete charging instructions, refer to the Operator's
Manual for your battery pack and charger models.
ASSEMBLY

OPERATION

19.2 V lithium-ion
®
19.2 V nickel-cadmium bat-
®
 Slide handle collar onto screw, seat hex end of collar
into hex hole.
 Thread auxiliary handle onto screw and secure tightly.
WARNING:
using this tool to help resist torque reactions. Bind-
ing or stalling of this product could lead to serious
personal injury.
C3 ENERGY INDICATOR WINDOW
See Figure 3, page i.
The C3 energy indicator window located on the side of the
handle, just above the base, will light when some Crafts-
man 19.2 V lithium-ion battery packs are installed and
®
have charge (315.113710, 315.PP2000, 315.PP2010,
315.PP2020, 315.PP2030).
NOTE: Feature will not light with Craftsman
nickel-cadmium battery packs.
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page i.
To install:
 Lock the switch trigger by placing the direction of
rotation selector in the center position.
 Place battery pack in the tool. Align raised rib on
battery pack with groove inside tool.
 Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool
before beginning operation.
WARNING:
your tool when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that could
cause serious personal injury.
To remove:
 Lock the switch trigger by placing the direction of
rotation selector in the center position.
 Locate latches on end of battery pack and depress to
release battery pack from the tool.
 Remove battery pack.
WARNING:
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
7 – English
Always use the auxiliary handle when
Always remove battery pack from
Battery products are always in operating
19.2 V
®