Table of Contents
Advertisement
The Gigaset SE505 dsl/cable
Procedure for installation and configuration
1. First install an Ethernet network card or a wireless
gaset PCI Card 54 or Gigaset PC Card 54 in the PC's you want to connect with the Gi-
gaset SE505 dsl/cable. The installation procedure can be found in the product's User
Guide.
When installing wireless network adapters you should note the fol-
i
lowing:
The default
2. Now install the router (refer to the section entitled "Installing the Gigaset SE505 dsl/
cable" on page 13).
3. Before the PC's can communicate with the router and with each other in a local net-
work, you have to change their network settings. Configure these network settings
on one PC first so that it can establish a connection to the router. You can then use
that PC to configure the router. To find out how to do this, refer to "Configuring the
local network" on page 18.
4. In a wireless connection you establish the link from the PC's wireless network adapt-
er to the router. This is described in the network adapter's operating instructions.
5. Now configure the router to activate the router's Internet access (refer to the section
"General configuration with Basic Setup" on page 51).
This will require the access data from your Internet Service Provider.
6. If you want to connect more PC's to the router, configure their network settings to
set up the local network (refer to the section entitled "Configuring the local network"
on page 18).
7. If you wish to use the router's other functions, e.g. the comprehensive security fea-
tures, use the router's Security Setup (see page 59) or Advanced Setup (see
page 66).
8
SSID
of the Gigaset SE505 dsl/cable is ConnectionPoint.
Network adapter
such as the Gi-
Advertisement
Table of Contents
