Table of Contents
Advertisement
Appendix
Symptom
No connection to the router's
configuration environment
Password forgotten or lost
You cannot access a resource
(drive or printer) on a differ-
ent PC
102
Possible cause and solutions
u
Use the ping command to check whether you can
establish a network connection to the Gigaset
SE505 dsl/cable.
u
Check the network cable between the PC you want
to use to administer the router and the Gigaset
SE505 dsl/cable.
u
If the PC you want to use is on the router's local net-
work, make sure that you are using the correct IP
address administration (see above).
u
If the PC you want to use is not on the router's local
network it must be authorised via Remote Manage-
ment.
u
Reset the router (see page 103).
Warning: Please bear in mind that this will restore all
configuration settings to the factory settings.
u
Make sure that TCP/IP has been installed and config-
ured on all the PC's on the local network and that the
PC's all belong to the same workgroup.
u
Check whether the resource has been released on
the PC in question and whether you have the neces-
sary access rights.
u
Printing: Check whether the printer has been set up
as a network printer.
Advertisement
Table of Contents
