Mitsubishi Electric G-50A Operation Manual page 13

(4) Selecting [ON/OFF/Prohibit/Permit (Pulse signal)] makes it possible to use pulse signals to run multiple
units, stop multiple units, prohibit local operation and permit local operation. In this mode, it is possible to
freely operate the remote control except during the pulse signal input.
Connection to G-50A (CN2)
4-2-5 Setting the Display Format
Select display or non-display of "unit of temperature" and "filter sign" in the display format. When the filter sign
display is set to "OFF," the filter sign on neither the LCD of the G-50A nor the monitor screen on the Web
browser will appear, even when the indoor unit detects a filter sign.
If the filter is regularly cleaned and the filter sign display is unnecessary, set it to [OFF].
(1) Select between [
ºC
(2) Select [ON] to display the filter sign and [OFF] not to.
1
2
3
4
5
6
7
8
9
Contact ON
Run
Contact OFF
Contact ON
Stop
Contact OFF
Contact ON
Prohibit
Contact OFF
Contact ON
Permit
Contact OFF
] and [ºF] as the unit of temperature.
Run
Stop
DC12V
：Pulse generator
0.5 - 1.0
Seconds
Run
Stop
0.5 - 1.0
Seconds
Permit
Prohibit
12
Prohibit
Permit
Stop
Permit