Reset Button - NETGEAR GS748T GS748T GS748T Hardware Installation Manual

Table 2-1. Front Panel LEDs
Label
Power
Speed/Link/ACT
SFP (MiniGBIC) Link/Act

Reset Button

The Reset button of the GS748T triggers a hardware reset of the switch.
location on the front panel. This action is equivalent to switching the unit power off and back on.
The last saved configuration is loaded into the switch as it resets. To operate the reset button, insert
a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs
should extinguish and light again as the switch performs its Power On Self Test (POST).
Physical Description
GS748T Smart Switch Hardware Installation Guide
Color Activity
On
Green
Off
On
Green
Blinking
Yellow On
None Off
On
Green
Off
v1.0, January 2007
Description
Power is supplied to the switch
Power is disconnected
A valid 1000Mbps link is established on
the port
Data transmission is occurring at
1000Mbps on the port
A valid 10/100Mbps link is established
on the port
No 10/100/1000Mbps link is
established on the port
A valid 1000Mbps link is established on
the port
No valid link is established on the port
Figure 2-3 shows its
2-3