Monterey 184 FS Owner's Manual page 13

Sport Boat_Sect_M_2011_Sport Boat_Sect_M.qxd 9/27/10 1:03 PM Page 6
Clear plastic (isinglass) is subject to ultraviolet (sunlight)
degradation over time. It may turn yellow-brown (a burnt
appearance) and get brittle. Two things that can accelerate this
degradation are:
1. Direct contact with aluminum or stainless steel frames. Use
"Standoffs."
2. In salt water areas, dried salt crystals on the plastic will
amplify sunlight. Wash after each use and/or windy day.
DON'TS
Do not subject acrylic material to high temperatures when polishing.
l
Do not use glass cleaning sprays, scouring compounds, or solvents like
l
acetone, gasoline, benzene, carbon tetrachloride or lacquer thinner.
Do not use masking tapes, duct tapes or packing tapes on your acrylic
l
materials.
Do not drill holes in your acrylic materials without proper drill bits (special
l
bits are used in acrylic material to avoid damage).
Stainless Steel
Marine grade stainless steel components such as hardware, cleats, eyes, and
rails offer superior corrosion resistance. When properly maintained, stainless
steel will not rust or stain, even in harsh saltwater environments. However, if
not maintained, stainless steel can rust, discolor, or even corrode. The
following guidelines will help keep stainless steel looking good for years to
come.
DO'S
Clean stainless steel frequently (daily in salt or polluted environments)
l
with mild soap and plenty of water. Any cleaner safe for use on glass is
usually safe for stainless.
Remove rust spots (especially around welds) immediately with a brass,
l
silver, or chrome cleaner. Irreversible pitting will develop under rust
allowed to remain on stainless for any period of time.
Remove rust stains on gelcoat. See dealer for recommended product
l
Protect stainless with waxes or polishes suitable for marine use.
l
DON'TS
Do not use coarse abrasives like sandpaper or steel wool which may
l
actually cause rusting.
M-6
NOTICE
.