Default Factory Settings; How To Set Up And Test Basic Wireless Connectivity - NETGEAR RangeMax WPN824 Reference Manual

Reference Manual for the RangeMax Wireless Router WPN824

Default Factory Settings

When you first receive your WPN824, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WPN824 router, use the procedures below to customize any of the settings to better meet your
networking needs.
Wireless Access List (MAC Filtering)

How to Set Up and Test Basic Wireless Connectivity

Note: If you use a wireless computer to configure WPA settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless router from a wired computer to make any further
changes.
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
Log in to the WPN824 firewall at its default LAN address of
1.
http://192.168.1.1) with its default user name of admin and default password of password, or
using whatever LAN address and password you have set up.
4-8
FEATURE
Wireless Access Point
SSID broadcast
SSID
11b/g RF Channel
Mode
Authentication Type
WEP
DHCP Server
DHCP range
202-10072-01, March 2005
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
NETGEAR
6
Auto 108
Automatic
Disabled
Enabled
192.168.1.2 to 192.168.1.254
http://www.routerlogin.net (or
Wireless Configuration