Wep Configuration Options; Wireless Channels - NETGEAR RangeMax WPN824 Reference Manual

Netgear wireless router reference manual
Hide thumbs Also See for RangeMax WPN824:
Table of Contents

Advertisement

WEP Configuration Options

The WEP settings must match on all 802.11 devices that are within the same wireless network as
identified by the SSID. In general, if your mobile clients will roam between access points, then all
of the 802.11 access points and all of the 802.11 client adapters on the network must have the same
WEP settings.
Note: Whatever keys you enter for an AP, you must also enter the same keys for the client adapter
in the same order. In other words, WEP key 1 on the AP must match WEP key 1 on the client
adapter, WEP key 2 on the AP must match WEP key 2 on the client adapter, and so on.
Note: The AP and the client adapters can have different default WEP Keys as long as the keys are
in the same order. In other words, the AP can use WEP key 2 as its default key to transmit while a
client adapter can use WEP key 3 as its default key to transmit. The two devices will communicate
as long as the AP's WEP key 2 is the same as the client's WEP key 2 and the AP's WEP key 3 is
the same as the client's WEP key 3.

Wireless Channels

The wireless frequencies used by 802.11b/g networks are discussed below.
IEEE 802.11b/g wireless nodes communicate with each other using radio frequency signals in the
ISM (Industrial, Scientific, and Medical) band between 2.4 GHz and 2.5 GHz. Neighboring
channels are 5 MHz apart. However, due to spread spectrum effect of the signals, a node sending
signals using a particular channel will utilize frequency spectrum 12.5 MHz above and below the
center channel frequency. As a result, two separate wireless networks using neighboring channels
(for example, channel 1 and channel 2) in the same general vicinity will interfere with each other.
Applying two channels that allow the maximum channel separation will decrease the amount of
channel cross-talk, and provide a noticeable performance increase over networks with minimal
channel separation.
The radio frequency channels used in 802.11b/g networks are listed in
Table D-4:
802.11b/g Radio Frequency Channels
Channel
Center Frequency
1
2412 MHz
2
2417 MHz
3
2422 MHz
Wireless Networking Basics
Reference Manual for the RangeMax Wireless Router WPN824
Frequency Spread
2399.5 MHz - 2424.5 MHz
2404.5 MHz - 2429.5 MHz
2409.5 MHz - 2434.5 MHz
202-10072-01, March 2005
Table
D-4:
D-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents