Pioneer DV-AX10 Service Manual page 98

DV-AX10
QQ
3 7 63 1515 0
Description
FL
of Error
ID can not read
71 An ID could not be read for 1 second or more.
during tracing
Subcode check
72
failure during
playback
ID can not read at An ID could not be read within 1 second after the
73
the startup AFB adjustment had been finished.
Subcode check
74
failure during startup
Timeout for reading
81 TOC of the
mechanism
controller
Timeout for reading
82
TOC of the system
controller
Timeout of
91 Door open took 10 seconds or more.
door open
Timeout of
92 Door close took 10 seconds or more.
door close
Communication A command could not be issued to DSP because
A1 timeout of DSP Command Busy (XCBUSY) was in force
command (XCBUSY = L) for a specified time (about 200
mS).
Command Busy (XCBUSY) was in force for a
TE Communication
L 13942296513 specified time (about 200 mS) before and after a
A2 timeout for reading
coefficient read command was issued to DSP, or
DSP coefficient
the address echo-back after command issuance
did not match the setup address.
Communication Command Busy (XCBUSY) was in force for a
A3 timeout for writing specified time (about 1024 mS) before and after
DSP coefficient the coefficient write command was issued to
DSP.
Communication Command Busy (XCBUSY) was in force for 200
µS during continuous coefficient writing, or
timeout for
A4
continuously writing before and after a continuous write command
DSP coefficient was issued to DSP.
A7 Servo DSP hang Servo DSP is hang when releasing the DAC mode.
In the tracing state during the backup sequence, codes could not be read for 1
Timeout error for
B1 second or more. In the backup sequence, tracking ON sequence of the servo DSP
backup
could not be completed even if more than 500 mS after the tracking ON command
was issued.
Retry error for
B2 Tracing impossible after retring the tracking ON for 3 times in the backup sequence.
backup
During tracing, runaway was detected after three iterations of backup operations for
B3 Retry error for trace
detecting runaway.
www
.
98
http://www.xiaoyu163.com
Causes if with a DVD
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Causes if with a CD
No frame could be read for 3
seconds or more.
No subcode could be read within 3
seconds after AFB adjustment had
been finished.
TOC readout took 30 seconds or
more.
Reading TOC of the system
controller took 30 seconds or more.
Q Q
3 6 7 1 3 1 5
co
.
9 4 2 8
Operation of the Unit
Stop
Stop
Opens (ID readout failure)
Opens (Subcode readout
failure).
Stop
Stop
Close
Open
No operation
0 5 8 2 9 9 4 2 8
No operation
No operation
No operation
Stops
Stops
Stops
m
9 9
9 9