Error Code - Pioneer DV-AX10 Service Manual

DV-AX10
QQ
3 7 63 1515 0

7.1.3 ERROR CODE

Error codes that are displayed on the FL display without using the remote control unit
FL Display
AV1 VER AV-1 chip is not a match with the program of system controller
CPU AERR CPU address error (Hardware is unusual.)
DMA AERR DMA address error (Hardware is unusual.)
Difference in versions of the internal ROM of the system controller and of the flash ROM,
FLASH ID
or bus line failure or reverse installation
FLASH WRP Write protect error of the flash ROM
Difference in part number of the flash ROM
FLASH SIG
(When the ROM which could't be used was used.)
Check sum error of the flash ROM (It exceeds the regular size.) or reverse
FLASH SUM
installation (Hardware is unusual.)
FLASH SIZE Size error of the flash ROM (Use 4 or 8 M-bit.)
ILLGAL The system controller fetched a code other than an operation code (Hardware is unusual.) No operation
RESERVE Undefined interrupt (Hardware is unusual.)
SLOT Inappropriate slot command issued (Hardware is unusual.)
Error codes that are displayed on the FL display by using the remote control unit
(Mechanism controller error)
To display: ESC + DISPLAY + DISPLAY; Location of the display: At the two digits of center of the FL display
To display the error history: ESC + DISPLAY + One shot; Location of the display: TV screen
Description
FL
of Error
Search could not be complete within 7
TE
L 13942296513
11 Search timeout
seconds.
A search could not be completed after 3
retries, search backup was executed 4
Search retry
times, or in a case of timeout (6 seconds)
12
error
while the unit was tracing 11 tracks or
more beyond the target while the search
operation was converging.
Tracing timeout Timeout (10.5 seconds) while tracing at
19
while converging the stage of convergence of a search.
Index 0 search
1B
error
Timeout of slider
22 inner Inside switch could not ON within 3 seconds.
circumference
Timeout of slider
23 outer Inside switch could not OFF within 2 seconds.
circumference
No FOK pulse
33 during When the focus was deviated continuously 20 times.
playback CLVA
www
If normal starting was impossible in the following three cases, disc-type sensing will
be retried if other errors occure excepting C5 error. However, when the focus error
Disc-type-
"33" was occured continuously 3 times, it is finished as "38 error" at the moment:
38
sensing error .
(1) startup with the first disc-type-sensing result, (2) forced startup with another disc
by designating the disc type, (3) forced startup with the original disc by designating
the disc type.
96
http://www.xiaoyu163.com
Possible causes
Causes if with a DVD
x ao
y
i
http://www.xiaoyu163.com
8
Causes if with a CD
Search could not be complete within 7
Q Q
3 6 7 1 3
seconds, and it could not enter the target
area within 7 seconds by VCD scan.
Backup against slider skip was executed
4 times during a search, or slider skip
twice resulted in starting from the read-in
point.
During Track (Index) Search, the search
for the beginning of a program could not
be completed within 3 seconds (20
seconds in the case of Index Search)
after positioning based on the TOC data
was completed.
u163
.
2 9 9 4 2 8
Operation of the unit
The sound may not out
with the specific audio.
No operation
No operation
No operation
No operation
No operation
No operation
No operation
No operation
No operation
Operation of the Unit
CD : Stops,
1 5 0 5 8 2 9 9 4
DVD : Continues operation
CD : Stops,
DVD : Continues operation
Stop
Stop
Stop
Stop
Adjusts focus at the innermost
circumference and tries to return
to its position where the error
was generated (for 3 times),then
opens. If the same error persists
after one retry, the tray opens.
m
(No FOK pulse)
co
Open
9 9
2 8 9 9