SOLIS 7212 User Manual page 36

▲
F I R S T U S E
• The humidifier can be used in surroundings with an ambient temperature bet-
ween 5° and 40°C, the relative room humidity must be under 90%.
1. Install the the cover and moisture outlet on the main body
of the appliance. (Ill. 1)
2. Take a 0.5 litre PET bottle and fill this with fresh, cold tap
water. The maximum temperature of the water must not
be above 50°C! Put not additives in the water! Caution:
the PET bottle must not hold more than 0.5 litres!
3. Take the appropriate bottle adaptor (3) and screw it onto
the bottle (Ill. 2). Turn the bottle, with the adaptor, upside
down and place the bottle and bottle adaptor into the ope-
ning in the cover. (Ill. 3)
4. Plug the plug into the socket on the side of the appliance
and the power adaptor into a power socket. (Ill. 4)
5. Switch the appliance on by turning the humidity control
clockwise. Set the control to a position between LOW and
HIGH. The further you turn it, the more intense the hu-
midification, the more water evaporates.
6. If the water bottle is empty, the vaporising unit in the eva-
porator switches off automatically. Nevertheless, you
should turn the humidity control to the "Off" position and
pull out the power adaptor from the socket as soon as you
realise that the water bottle is empty.
7. To switch off please set the humidity control to the "Off"
position and pull out the the power adaptor from the so-
cket.
• Note: If you wish to use the appliance again after a long
time, rinse the bottle and the vaporising compartment with
fresh, cold tap water and pour this away. Fill the water
bottle with fresh tap water.
36
Ill. 1
Ill. 2
0,5 ltr.
Ill. 3
Ill. 4