Pioneer DV-636D Service Manual page 87

QQ
3 7 63 1515 0
LBXJ, RLXJ/NC, RLXJ/RB and RLXJ/RD Types
1
DIGITAL OUT
CONTROL
OUT IN
(*The TV SYSTEM switch is not present on LBXJ Type.)
1
CONTROL jacks
TE
L 13942296513
Use to connect this player to another component bearing the
Pioneer Î mark. This lets you control this unit as though it
were a component in a system. Player operations are then
performed by pointing the remote control at the component
that the player is connected to.
2
COMPONENT VIDEO OUT jacks
If your TV or monitor has component video inputs, you can
produce a higher quality picture on your TV or monitor by
connecting to the component video outputs on this unit.
When using these jacks, be sure to set VIDEO OUT SELECT
to the right position.
3
AUDIO OUT (2CH) jacks
Use to output two-channel audio (analog) to the audio stereo
inputs on a TV or stereo amplifier. If you are connecting to a
receiver that has both digital and analog input jacks for DVD
player connection, it may be beneficial to make both
connections.
4
AUDIO OUT (5.1CH) jacks
Use to output 6 discrete audio channels of decoded digital
audio to a receiver or amplifier with discrete audio inputs.
5
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet.
6
VIDEO OUT SELECT switch
www
Use to set which output is used to output the video signals.
Select either video/S-video or component video signal output
depending on the connections you make.
.
http://www.xiaoyu163.com
2
COMPONENT
VIDEO OUT
Y
S-VIDEO OUT
VIDEO OUT
P
OPT. 1
1 B
TV SYSTEM
PAL AUTO
NTSC
2
2
P
R
0 9*
8 7
x ao
y
i
http://www.xiaoyu163.com
8
3 4
AUDIO OUT (2CH) AUDIO OUT (5.1CH)
CENTER
VIDEO
OUT
SELECT L L
R R
1 2
SUB
FRONT
SURROUND
WOOFER
• RLXJ/NC, RLXJ/RB and RLXJ/RD Types
6
7
S-VIDEO OUT jacks
Q Q
3 6 7 1 3
If your TV or monitor has an S-video input, clear picture
reproduction is possible by connecting the player to your TV or
monitor via the S-Video jack.
When using this output, be sure to set VIDEO OUT SELECT to
the left position.
8
VIDEO OUT jacks
Connect to the video input on a TV or monitor or AV amplifier
or receiver with video input capability.
When using this output, be sure to set VIDEO OUT SELECT to
the left position.
9
TV SYSTEM switch* (except for Taiwanese model)
Use to change the TV signal mode to either PAL or NTSC
according to the type of TV and disc to be used. When the
switch is in the AUTO position, the player outputs the format
on the disc as is.
0
DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on discs. You
can output the digital signal via either coaxial or optical output
jack to an AV amplifier or receiver.
u163
.
2 9 9 4 2 8
5
AC IN
1 5 0 5 8 2 9 9 4
m
co
DV-636D
9 9
2 8 9 9
87