NETGEAR WAG302 Reference Manual page 70

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Figure 5-1: Advanced IP Settings for Wireless Clients screen
You may configure the Advanced IP Settings for Wireless Clients if you are a network system
administrator.
• Use AP as DHCP Server: You may turn on this option and the Access Point will function as a
DHCP Server for Wireless Clients only. The Access Point will provide the pre-configured
TCP/IP configurations for all wireless stations connected to this Access Point.
There are two options available for managing the wireless clients:
– Accept DHCP Enabled Wireless Clients Only: The Access Point can only provide the
TCP/IP configurations to those wireless clients with the DHCP enabled.
– Accept Both DHCP Enabled and Static IP Configured Wireless Clients: The Access
Point will support wireless clients with the DHCP enabled and the static IP configured.
You need to configure the following TCP/IP configurations for using Access Point as a DHCP
Server for Wireless Clients.
– Starting IP Address: Type the starting IP address can be assigned from the DHCP server
on this Access Point.
– Ending IP Address: Type the Ending IP address can be assigned from the DHCP server
on this Access Point
5-2
202-10078-01
Advanced Configuration