NETGEAR WAG302 Reference Manual page 60

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
This screen shows the following parameters:
Table 4-1. General Information Fields
Field
Access Point Information
Access Point Name
(NetBIOS name)
MAC Address
Country/Region
Firmware Version
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings 11a
Access Point Mode
Operating Mode
Wireless Network Name
(SSID)
Channel/Frequency
WEP/WPA
4-6
Description
The default name may be changed if desired.
Displays the Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
Identifies the operating mode of the WAG302: Access Point, Point-to-point
bridge, Multi-point bridge or Repeater.
Identifies the 802.11 operating mode of the WAG302.
Displays the wireless network name (SSID) being used by the wireless port
of the wireless access point. The default is NETGEAR_11a.
Identifies the channel the wireless port is using. 52 is the default channel
"Wireless Channels" on page B-7
setting. See
on each channel.
WEP/WPA setting.
202-10078-01
for the frequencies used
Management