Connecting Power; Portable Operation - Technika TK9PD14 Owner's Handbook Manual

POWER CONNECTION
Your DVD player may be powered by the internal
rechargeable battery for portable operation, from the AC
mains via an AC adaptor or from the 12V DC outlet in a
car via the DC adaptor. The internal battery can also be
charged from either the AC or DC adaptor.
CAUTION: Use only the AC and DC adaptors supplied with
the unit.
CONNECTING THE AC OR DC ADAPTOR
Connect the DC plug of the supplied adaptor (mains or
vehicle) into the DC-In jack on the side of the player.
Plug the Adaptor into the mains point (or vehicle
accessory point) and switch on the power. The player is
now ready for use.
AC Mains connection
SETUP SOURCE AV OUT ON OFF DC IN 9-12V
Vehicle 12V DC connection
AV OUT ON OFF DC IN 9-12V
SETUP SOURCE

PORTABLE OPERATION

If you want to use the player without external power you
will need to charge the battery. The battery will charge
whenever an AC or DC power source is connected.
The amount of time taken to charge the battery depends
on the amount of residual charge remaining but it could
take several hours.
When the battery is charging the light at the front of the
player will glow red. When the battery is fully charged the
light will change to green. You may now disconnect the
mains adaptor.
DURING BATTERY OPERATION:
If there is no display when the player is turned on:
This is not a fault condition but due to a flat battery.
• Switch the player off, connect the charger as described
above and charge the battery for six hours.
When the battery is running out:
• The player will display a "Low Battery" warning.
• After a short period the player will shut down.
• You must charge the battery as soon as possible.
To conserve power:
• Always switch the player off when it is not connected
to the adaptor or you will drain the battery.
13
POWER CONTROL
Switching on the player:
• Slide the power switch to the ON position.
The player will switch on and the screen will light. If a
disc is loaded, it will start to play automatically.
Switching off the player:
• Slide the power switch to the OFF position.
The player will switch off.
Auto Standby:
To conserve power, this player features Auto standby.
When Auto standby is enabled, the player will
automatically set to standby if not used for a period of 3
or 4 hours (selectable in the setup menu).
Refer to page the Setup section for more details about
setting Auto standby times.
• To switch on after Auto standby, slide the power
switch to the OFF position, then back to the ON
position.