Environment Protection - Smeg SIHP3+WG4 Directions For Use Manual

ENVIRONMENT PROTECTION

 The packaging materials is ecological and can be recycled.
 The worn hob has to be eliminated in conformity with the rules are enforce in your place
of residence.
Installation instructions
The installation comes under the exclusive responsability of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
Fitting - installing:
 The piece of furniture or the support in which the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
 The mural rods of edge must be heat-resisting.
 The hobs are classified as "Y" class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall units
or a wall at one side. On the other side, however, no unit or divider must stand higher
than the hob.
 Ensure that there is a distance of 50 mm between the hob and the wall or sides.
 The cut out sizes are:
Model Worktop Cut-out
Width
60 560
67 640
78 750
97 940
CombiWok 765
 Materials which are often used to make worktops expand on contact with water. To
protect the cut out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage into
the supporting furniture. This gasket guaranties a correct seal when used in conjunction
with smooth work top surfaces.
 Not to install the hob to the top of a not ventilated oven or a dishwasher.
 To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good air
circulation of the electronic device.
 To guarantee between the work top and the top of the drawer or oven a space of 5 mm
to allow the exit of the air flow.
 If a drawer is placed under the work, avoid to put into this drawer flammable objects (for
example : sprays) or not heat-resistant objects.
 The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. In case of absence of instructions respect a
distance minimum of 760 mm.
 The connection cord should be subjected, after builting, with no mechanical constraint,
such for example of the fact of the drawer.
 The installation of the hob in nonstationary sites ( for example : boat ) should be
undertaken by specialists.
Glass size
Depth Width Depth
490
590 520
490 670 520
490 780 520
440 970 460
495
780 510
13
Glass Cut-out
(if "flushline" integration)
Thick. Width Depth
4 596 526
4 676 526
4 786 526
4 976 466
6 786 516
Thick. Radius
4 11
4 11
4 11
4 11
6 7.5