Belt Pulley Installation Onto Keyway-Type Crankshaft - Subaru EX13D Instructions For Use Manual

3. KEY SWITCH CABLE
If a remote key switch is used, select wires of proper gauge to
connect it and magnetic switch of the engine.
Cable length Cable dia.
Less than 1.5m
1.5 m to 3 m
3 m to 5 m
4. WIRING
JP
CABLE
EN
To KEY SWITCH
(TERMINAL "ST")
US
FR
EARTH WIRE
DE
NL
BATTERY
ES
IT
PT
(1) Connect positive (+) terminal of the magnetic switch and
GR
positive (+) terminal of the battery with battery cable.
NO
SE
FI
Make sure the polarity of battery terminals.
Never connect the battery cable with the battery
DK
negative (-) terminal.
When connecting the battery cable with the
RU
battery negative (-) terminal, diode rectifi er
chips will be burned out or damaged in a
PL
moment.
CN
AR
(2) Ground negative terminal of the battery to the engine body
or machine with ground wire.
(3) When installing the key switch on the machine, install with
its drain hole at the bottom.
NOTE
Tighten bolts and nuts on terminals securely so that they will
not be loosened by vibration.
6
Wire gauge
AWG
BWG
(BS)
1.5 mm 14 16
1.9 mm 12 14
2.4 mm 10 13
MAGNETIC SWITCH
CAUTION
5. WIRING DIAGRAM
(RECOIL STARTER MODELS)
Spark plug
JIS
AV1.25
AV2
AV3
Flywheel
WIRING DIAGRAM
(ELECTRIC STARTER MODELS)
Spark plug
Magneto
Charge coil
EX27
To Key switch (B)
To Diode rectifier
LA408
To Battery
Optional hardware shown by dotted lines.
5. BELT PULLEY INSTALLATION
ONTO KEYWAY-TYPE CRANKSHAFT
When installing the belt pulley and/or clutch onto keyway-type
crankshaft (PTO shaft), proper and correct arrangements are
needed.
The following illustration shows the correct installation of the
applicable component parts.
Bolt
Washer
PTO shaft
Black
To LED
Lamp
Ignition coil Oil sensor
control unit
Oil sensor
To LED Lamp
Black
Ignition coil
Key switch
+M
-M
AC
ST
Diode
B
rectifier
LA106
LA406
LA306
LA108
To Key switch
Magnetic switch
(ST)
Electric starter
Electric
starter
Pulley
Key
Oil sensor
control unit
Oil sensor
Battery