Table of Contents
Advertisement
Step 3. Attach the Mounting Hardware to the Rack Enclosure
To attach the mounting hardware, you will need the following items:
v Rack-Mounting Template
v 2 Rack Rails
v Cable Management Arm
v Rack-Mounting Kit Envelope
v Screwdriver or Nutdriver
1. Install the slide-rails and the cable management arm on the mounting rails of the rack enclosure.
Note: If you do not have the rail template, go to "Rail Positioning Without a Template" on page 14.You
must align the rack slide rails correctly. Otherwise, the installation cannot be completed
successfully.
a. Position the template on the front rack-mounting rails, aligning the holes.
b. Install the nut clips (item 8 in the following illustration), using the locations shown on the template.
c. Install the EIA plates (items 4 and 7 in the following illustration), and attach them to the
rack-mounting rail with an M5 rack screw in the lower of the two nut clips.
8
7
6
5
4
1 Rack
2 Left Rail (from front)
3 Right Rail (from front)
4 Right EIA Plate (from front)
1
2
3
5 M5 Screw for EIA Plates
6 M5 Screw for Rails
7 Left EIA Plate (from front)
8 M5 Nut Clip
Chapter 2. Installing the pSeries 650
11
Advertisement
Table of Contents
