NETGEAR CVG824G Reference Manual page 35

Figure 2-9
To add a device to the Access List:
1. Add a device to the Access List using either of the following methods:
a. If the computer is in the Connected Wireless Devices table, click the radio button of that
computer to capture its MAC address; or
b. Specify the MAC address of the device to be added to the Access List in the Add Access
Filter fields. The MAC address can usually be found on the bottom of the wireless device.
Note: If no Device Name appears when you enter the MAC address, you can type a
descriptive name for the computer that you are adding.
2. Click Add.
3. Repeat Steps a or b and 3 for each wireless PC that you are adding.
4. Click Apply to save these changes. Now, only devices on this list will be allowed to wirelessly
connect to the gateway.
To delete an entry from the Access List:
Check the corresponding radio button in the Access List and click Delete.
Wireless Configuration
Wireless Cable Voice Gateway Model CVG824G Reference Manual
v1.0, November 2006
2-13