Adjusting The Fastening Torque; Installing Or Removing Driver Bit Or Drill Bit - Makita 6017D Instruction Manual

CAUTION:
Always set the speed change lever fully
•
to the correct position. If you operate
the tool with the speed change lever
positioned halfway between the "I" side
and "II" side, the tool may be damaged.
Always make sure that the gear is
•
engaged properly by running the tool
under no load after sliding the speed
change lever to the desired speed
position. If you operate the tool with the
gear engaged improperly, the tool may
be damaged.
Do not use the speed change lever
•
while the tool is running. The tool may
be damaged.

Adjusting the fastening torque

For model 6019D only
2
3
002099
The fastening torque can be adjusted in 6
steps by turning the adjusting ring so that its
graduations are aligned with the pointer on
the tool body. The fastening torque is
minimum when the number 1 is aligned with
the pointer, and maximum when the
marking is aligned with the pointer.
The clutch will slip at various torque levels
when set at the number 1 to 5. The clutch is
designed not to slip at the marking.
Before actual operation, drive a trial screw
into your material or a piece of duplicate
material to determine which torque level is
required for a particular application.
1. Pointer
1
2. Weak
3. Strong
4. Torque adjusting
ring
4
NOTE:
The adjusting ring does not lock when
•
the pointer is positioned only halfway
between the graduations.
Do not operate the tool with the
•
adjusting ring set between the number
5 and the marking. The tool may be
damaged.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the
tool.
Installing or removing driver bit or
drill bit
1
002111
Hold the ring
counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the
sleeve counterclockwise.
When not using the driver bit, keep it in the
bit holders. Bits 45 mm (1-3/4") long can be
kept there.
7
1. Tighten
2. Sleeve
3. Ring
2
3
and turn the sleeve