Page 1
Cordless Driver Drill MODEL 6017D MODEL 6018D MODEL 6019D 002030 I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Intended use The tool is intended for drilling and screw driving in Director wood, metal and plastic. MAKITA INTERNATIONAL EUROPE LTD. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND Responsible manufacturer: Makita Corporation Anjo Aichi Japan...
GENERAL SAFETY RULES GEA002-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.
20. Maintain power tools. Check for misalignment or 25. Use power tools only with specifically desig- binding of moving parts, breakage of parts and nated battery packs. Use of any other battery any other condition that may affect the power packs may create a risk of injury and fire.
Page 5
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE ENC004-1 (1) Do not touch the terminals with any con- Before using battery cartridge, read all instruc- tions and cautionary markings on (1) battery ductive material. charger, (2) battery, and (3) product using bat- (2) Avoid storing battery cartridge in a con- tery.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 002045 • Always switch off the tool before insertion or removal of the battery cartridge.
Page 7
Speed change 002092 To change the speed, first switch off the tool and then slide the speed change lever to the “II” side for high speed or “I” side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job.
OPERATION Screwdriving operation For model 6017D/6018D Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool. Release the trigger just as the screw bottoms out. If the trig- ger is not released, the screw may strip out the hole or the screw and/or bit may be damaged.
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.