Krups XL2000 User Manual page 8

KR_MOUSSEUR-LAIT_XL2000_Mise en page 1 21/11/13 16:41 Page6
English
PROBLEMS AND CORRECTIVE ACTIONS
Possible problems
The appliance will not
start, the recipe button
flashes.
The appliance will not
start, all of the recipe
buttons flash.
The buttons are flashing
abnormally.
It is not frothing.
Motor operates in fits
and starts during the
entire recipe.
The chocolate is not
completely melted.
If the problem continues, please contact the service centre in your country.
GUARANTEE
This product has been designed for domestic use only. Any commercial use, inappropriate use
or failure to comply with the instructions or safeguards, the manufacturer accepts no
responsibility and the guarantee will not apply.
If you have any questions, please contact the customer service of your country. It is preferable
to have the appliance close to hand when calling, as well as the serial number marked on the
bottom of the appliance.
If you have any problems or queries, please contact our Customer Relations Team first for expert
help and advice:
0845 330 6460 - UK - (01) 677 4003 - Ireland - or consult our website - www.krups.co.uk
This product contains an electronic board in the lower part, any introduction of water or other
liquid in this part could damage the product. In this case the guarantee will not apply.
6
Probable causes
The temperature of the
pot is too high.
The emulsifier is blocked. Empty the preparation, remove the
Water has leaked into the
base of the appliance
during cleaning.
The mixer is missing or is
not positioned correctly.
`
Water has leaked into the
base of the appliance
during cleaning.
There is too much
chocolate in
preparation.
Corrective actions
Wait for the light to stop flashing and
press the button for the desired recipe
again.
emulsifier and clean your jug and
emulsifier.
Leave to dry for 24 hours.
Empty out the preparation and
reposition the mixer.
Leave to dry for 24 hours.
Reduce the amount of chocolate or
the make the recipe with the cappuccino
function.