Low Battery Alert; Turn On The Scanner - Uniden UBC75XLT Owner's Manual

Table of Contents

If the batteries are good, the scanner charges the batteries.

and it operates normally. If the scanner cannot immediately

determine if the batteries are good and can be charged, it

checks them and displays the battery icon. If the scanner

judges the batteries are good, the scanner starts charging

and the battery icon disappears. If it cannot regard the

batteries as good in 60 seconds, the scanner stops checking

and the battery icon blinks.

Low Battery Alert

The Low Battery Alert tone sounds every 15 seconds and

the battery icon fl ashes when the battery voltage is low. If it

drops below the threshold, the scanner automatically shuts

off until the battery is recharged.

Turn on the scanner after it has been completely charged

(Ni-MH batteries) or alkaline batteries have been installed.

Note: Make sure the antenna is connected before you turn on

the scanner.

You can select the band plan (Band Plan 1 or 2) when

you turn on the scanner (default = Band Plan 1). Press

and hold the

scanner and then press and hold 1 for Band Plan 1 or

2 for Band Plan 2. The band plan will remain until you

change it again.

If this is the fi rst time you have turned on the scanner,

All LocOut

have been saved into channels. Press Srch to begin

searching.

UBC75XLT_UB372BV_20130401.indd 23

key for 2-3 seconds to turn on the

displays. This means that no frequencies

2013/04/02 11:08:34

Table of Contents

Show Quick Links

Table of Contents