Uniden UBC75XLT Owner's Manual page 9

Three Power Options - Use the supplied USB cable to
charge the UBC75XLT through your computer or other USB
charging port. You can also power the scanner using two AA
rechargeable Ni-MH batteries or optional alkaline batteries
(not included).
Key Confi rmation Tones - the scanner sounds a tone when
you perform an operation correctly, and an error tone if you
make an error.
Battery Low Alert - warns you when battery power gets
low. The Battery Low icon fl ashes (
tone sounds every 15 seconds until the scanner is recharged,
turned off , or drained completely.
Battery Save - works when there is no transmission for 1
minute in Scan Hold mode and in any Search Hold mode
(does not work in Priority Scan and Close Call modes). This
feature turns off RF power for 1 second and turns it on in
300ms intervals to extend the battery life.
Scan/Search Delay/Resume - controls whether the scanner
pauses at the end of the transmission to wait for a reply. You
can set the Delay time for each Channel, Close Call, Custom
Search, and Service Search mode.
Step Frequency - let you set your desired step frequency
during Quick Search, Custom Search, AIR Service Search, and
Close Call.
Modulation Type - let you set your desired modulation type
(AM or FM) during Quick Search, Custom Search, CB Service
Search, HAM Service Search, Close Call, and each Channel.
UBC75XLT_UB372BV_20130401.indd 9 UBC75XLT_UB372BV_20130401.indd 9
) and a battery low
9
2013/04/02 11:08:33 2013/04/02 11:08:33