Dhcp; Dhcp Settings - TP-Link tl-wr845n User Manual

Access Time - During this time the wireless stations could accessing the AP.


Note:
The range of bandwidth for Guest Network is calculated according to the setting of Bandwidth
Control on the page "Bandwidth Control > Control Settings".
4.8

DHCP

There are three submenus under the DHCP menu: DHCP Settings, DHCP Clients List and
Address Reservation. Click any of them, and you will be able to configure the corresponding
function.
4.8.1

DHCP Settings

Choose menu "DHCP > DHCP Settings", you can configure the DHCP Server on the page.The
router is set up by default as a DHCP (Dynamic Host Configuration Protocol) server, which
provides the TCP/IP configuration for all the PC(s) that are connected to the router on the LAN.
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must

have another DHCP server within your network or else you must configure the computer
manually.
Start IP Address - Specify an IP address for the DHCP Server to start with when assigning

IP addresses. 192.168.0.100 is the default start address.
End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP

addresses. 192.168.0.199 is the default end address.
TL-WR845N 300Mbps Wireless N Router
-44-