Operating; Gas Flame Adjustment - Mirage SERIES A Installation And Operating Instructions Manual

OPERATING

Once a pilot light has been established, the unit may be operated one
of two ways:
Fig. # 2
BURNER
CONTROL
OFF
Burner Control Dial
HIGH
shown in OFF position
Manual:
1) Turn burner control dial to desired setting. (Set to Hi, Med, or Low
only - do not operate in between settings. See Fig. # 2) To turn unit
off, turn burner control dial to "OFF" position.
Remote:
Optional wall switch or wall thermostat is required. (Fig. # 3)
f i r e - p a r t s . c o m
1) Turn burner control dial to desired setting. (Set to Hi, Med, or Low
only - do not operate in between settings. See Fig. # 2.) The unit may
be turned on or off via wall switch, or automatically by the wall
thermostat.
LOW
MED
Fig. # 3
Extend Shutdown:
1) Partially depress and turn gas control dial clockwise past "PILOT"
to "OFF" position.
To re-light unit, see "lighting instructions" section.
Note: When lit for the first time, the appliance will emit a slight odour for
a couple of hours. This is due to the curing of paints, sealants and
lubricants in the manufacturing process. This condition is temporary.
Open doors and windows to ventilate area.

GAS FLAME ADJUSTMENT

The air shutter on the burner venturi tube controls the primary combus-
tion air to the gas burner. Although it is preset at the factory, some
adjustment may be necessary to obtain desired flame and to eliminate
carbon deposits. (See Fig. # 4 for proper flame pattern)
Fig. # 4
To Adjust: (See Fig. # 5)
1) Loosen retaining screws and open left side panel to expose controls
2) Move air shutter adjustment rod in or out until proper flame is
achieved.
3) Close control side panel.
Fig. # 5
Caution: Proper air shutter setting is a must. The flame should be just
orange and "lazy". It should NEVER be set to create sooting on internal
parts and glass. Open air shutter gradually until sooting stops.
5