Log Set - Mirage SERIES A Installation And Operating Instructions Manual

LOG SET

The log set comes installed in the appliance from the factory. If the logs
have to be removed for cleaning, they must be handled carefully as they
are very fragile. To re-install the log set, follow this procedure:
1) Place the back log on the rear tabs of the burner assembly, with flat
side facing rear and bark side forward.
2) Place the front log on the tabs located at the front of the burner. The
log is notched to fit over top of the pilot.
3) The top "Y" log bridges across from the front log to the rear log. The
log should be properly seated in the relief of the front and rear log.
Step 1
Back Log Placement
f i r e - p a r t s . c o m
Step 2
Front Log Placement
Back Log
Front Log
Top Log
Step 3
Top Log Placement
Note: Improper placement of logs may cause soot-
ing on internal parts and glass.
Fig. # 16
13