Leds; Table 2-1. Led Descriptions - NETGEAR ETHERNET SWITCH SW108 Installation Manual

LEDs

You use LEDs on the Model SW108 switch to monitor and diagnose the devices. LEDs on the
front panel of the switch and two LEDs on each port allow you to identify the following
information:
• Status of the switch power supply
• Data transmission or receive activity
• Collision occurrence
• Full- or half-duplex transmission
Table 2-1 describes each LED on the front panel of the switch. See Figure 2-1 for the locations
of the LEDs.
Table 2-1. LED descriptions
Label Color
Power Green
Rx/Tx/Collision Green
Yellow
Link Green
FDX Green
Physical Description
Installation Guide for the Model SW108 Ethernet Switch
Activity Description
On Power is supplied to the switch.
Off Power is disconnected.
On or Packet transmission or reception is occurring on the port.
blinking
Off There is no packet transmission or reception occurring on
the port.
Blinking Data collision is occurring on the port. The blinking action
corresponds to the amount of collisions.
When a collision occurs, the connected device pauses
and transmits again after waiting a specified time.
A moderate amount of collision is normal.
On A valid link is established on the port.
Off A link is not established on the port.
On The port is operating in full-duplex mode.
Off The port is operating in half-duplex mode.
2-3