Physical Details; Rear Panel - NetComm NP5410 User Manual

Physical Details

Rear Panel

Antenna Connection
Selection Switch
Power Input
INIT Button
LAN Cable Selection Switch
X Crossover:
II Straight:
Power Input
LAN
Rev. 1 - YML675
NP5410 Wireless Ethernet Bridge User Guide
"INIT" means "Initiation". Press and hold this button
to reboot and reset the current configuration to factory
default settings. The left indicator "DIAG" on NP5410
will be off and then begin blinking. This initiation action
will be completed when the indicator "DIAG" light is
always green instead of blinking.
The RJ-45 port Tx and Rx lines will be reversed. Use
this setting when you are connecting the supplied
straight through ethernet cable directly to a PC.
The RJ-45 port Tx and Rx lines are normal. Use this
setting when you are connecting the supplied straight
through ethernet cable directly to a Hub or Switch.
Use the power adapter supplied with the NP5410
Use standard Ethernet cable (RJ-45 connector) to
connect your PC, hub/switch or broadband router/
modem to this LAN port.
INIT Button
LAN Cable
www.netcomm.com.au
Page 5