Network Connection - Samsung 7000 series User Manual

Programming manual (487 pages)

User manual (193 pages)

System administration manual (46 pages)

Table of Contents

Available languages

You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or wireless

connection.

Network Connection - Wireless

You can connect your TV to your LAN through a standard wireless router or modem.

The LAN Port on the Wall

This TV supports the IEEE 802.11a/b/g and n communication protocols. Samsung recommends using IEEE 802.11n. When

you play video over a network connection, the video may not play smoothly.

Most wireless network systems incorporate a security system that requires devices that access the network through an access

point or AP (typically a wireless IP Sharer - router or modem) to transmit an encrypted security code called an access key.

Your TV is compatible with the following security protocols:

y Authentication Mode: OPEN, SHARED, WPAPSK, WPA2PSK

y Encryption Type: WEP, TKIP, AES

If you select Pure High-throughput (Greenfield) 802.11n mode and the Encryption type is set to WEP, TKIP or TKIP AES

(WPS2Mixed) on your AP or wireless router, Samsung TVs will not support a connection in compliance with new Wi-Fi

certification specifications.

Configuring the Network Connection - Wireless

The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP) to configure network

connections automatically. If you have a Static IP network, see your user's manual for configuration instructions.

To configure your network connection for a network that uses

DHCP, follow these steps:

1. Connect your TV to your network as shown in the illustration

above.

2. Turn on your TV, press the

the select Network → Network Settings.

3. Select the Wireless(General), press ENTERE, and then

press ENTERE again.

4. The Network function searches for available wireless networks.

When done, it displays a list of the available networks.

5. In the list of networks, press the u or ▼ button to select a

network, select Next, and then press ENTERE.

6. If you have selected a wireless router that has security, the

Security Key screen appears. Enter the Security key (Security key or PIN), select Next, and then press ENTERE.

✎

When you enter the Security Key (Security key or PIN), use the u / d / ◄ / ► buttons on your remote to select

numbers and characters.

7. The Network connection screen appears and verifies the network connection. When the connection has been verified, the

"Internet is connected successfully" message appears. Network set up is complete.

✎

For more detailed information, see "Wireless Network Connection" in the e-Manual.

[UD7000-NA]BN68-03435E-01L03.indb 17