Hood Exhaust Louver Removal; Removal Of Oven From Wall; Outer Case Removal - Frigidaire CFMV152KW Servicing Manual

Section 4 Component Teardown
NOTE
The following adjustments or component replacement
can be performed without removing the oven from the
wall.
1. Hood lamps, sockets, grease filter and charcoal
filter.
2. Base cover and hood lamp glass assembly.
3. Turntable motor.
4. Hood exhaust louver.
5. Control panel assembly or components.

Hood Exhaust Louver Removal

1. Disconnect the power supply cord.
2. Open the oven door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the two (2) screws on the top holding the
hood exhaust louver to oven cavity front face plate.
5. Pull the hood exhaust louver from the oven cavity by
pushing the right and left tabs of the hood exhaust
louver to remove.
6. Now, the hood exhaust louver is free.
Push
Tab (left )
Figure 4-1.
4-2
Hood Exhaust
Louver
Push
Tab (right)

Removal Of Oven From Wall

(Two persons recommended to remove the oven)
1. Disconnect the power supply cord, and uncoil the
power supply cord.
2. To discharge the high voltage capacitor, wait for 60
seconds.
3. Remove the turntable tray and support from the
oven cavity.
4. If the exhaust damper assembly is installed, remove
the one (1) screw holding the exhaust damper
assembly to the rear stay, and remove the exhaust
damper assembly by sliding it backward.
5. Remove the three (3) screws holding the oven
(outer case cabinet) to the top cabinet.
6. While supporting the front of the oven, pull down
the three (3) mounting levers and release the oven
from the unit mounting plate.
7. Pull the power cord out of the wall cabinet and
remove the oven.
8. The oven is now free and can be placed on the work
surface selected for servicing the oven.
9. Installation is the reverse of this procedure.

Outer Case Removal

Remove the oven from the wall and proceed as follows:
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove two (2) screws holding the top stay to the
hood fan motor or the oven, and remove it.
5. Remove the six (6) screws from the rear of the outer
case cabinet and two (2) screws at right,and five (5)
screws at top.
6. Slide the outer case cabinet back about inch (3 cm)
to free it from retaining clips on cavity face plate.
7. Disconnect the three (3) pin connector of the power
supply cord from the wiring harness and remove the
power supply cord together with the outer case.
8. Nip the cord bushing with bushing pliers and release
it from the outer case cabinet.
9. Remove the cord bushing and the power supply cord
from the outer case cabinet.
CAUTION
Discharge the high voltage capacitor before
touching any oven components or wiring.