Door Replacement - Frigidaire CFMV152KW Servicing Manual

Section 4 Component Teardown
After adjustment, check the following.
1. In and out play of door remains less than 0.5mm
when in the latched position. First check upper
position of latch hook, pushing and pulling upper
portion of door toward the oven face. Then check
lower portion of latch hook, pushing and pulling
lower portion of the door toward the oven face.
Both results (play in the door) should be less than
0.5mm.
2. The door sensing switch, and secondary interlock
switch interrupt the circuit before the door can be
opened.
3. Monitor switch contacts close when door is opened.
4. The contact of door sensing switch and secondary
interlock switch open within 1.2mm gap between
right side of cavity face plate and door when door is
open.
5. Re-install outer case and check for microwave
leakage around door with an approved microwave
survey meter. (Refer to Microwave Measurement
Procedure.)
Latch Heads
Door
Figure 4-3. Latch Switch Adjustments
4-10
Latch Hook
Door S ensing
Sw itch
Monitor Switch
P rimary Interlock Switch

Door Replacement

Removal
1. Disconnect the power supply cord and remove the
oven from wall and remove outer case. (Refer to
procedure of "Removal of Oven from Wall" and
"Outer case Removal")
2. Open the door and block it open.
3. To discharge high voltage capacitor, wait for 60
seconds.
4. Remove the three (3) screws holding the hood
exhaust louver to the oven cavity front face plate.
5. Remove the hood exhaust louver from the oven
cavity by pushing the right and left tabs of the hood
exhaust louver. (Refer to the procedure of "HOOD
EXHAUST LOUVER REMOVAL".)
6. Insert a putty knife (thickness of about 0.5mm) into
the gap A between the door stopper and the choke
cover as shown in Figure 4-5 to free engaging parts.
7. Lift up the door stopper.
8. Door stopper is now free from the door assembly.
9. Lift up the door assembly to release the upper and
lower door hinge pins from the upper and lower
oven hinges.
10. Now, the door assembly is free.
NOTE
When the individual parts are replaced, refer to "Door
Disassembly".
Reinstall
1. On re-installing door, insert the lower oven hinge to
lower door hinge pin.
2. Insert the upper oven hinge to the upper door hinge
pin.
3. Shut the door (close the contacts of interlock
switches).
4. Make sure upper and lower oven hinges are inserted
into the upper an lower door hinge pins.
5. Make sure the door is parallel with oven face lines
(left and upper side lines) and door latch heads pass
through latch holes correctly.
6. Re-install the door stopper to the door assembly.
7. Re-install the hood exhaust louver to the oven cavity
front face plate with the three (3) screws.