Download  Print this page

Hood Exhaust Duct - Frigidaire FGMV174KFA Installation Instructions Manual

Over the range
Hide thumbs

Advertisement

3 ELECTRICAL GROUHDIHG i NSTRUCTiONS
4 HOOD EXHAUST DUCT
This appliance must be grounded. This oven is equipped with
a cord having a grounding wire with a grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded in accordance with the National Electrical Code and
local codes and ordinances. In the event of an electrical short
circuit, grounding reduces risk of electric shock by providing
an escape wire for the electric current.
WARNING - Improper use of the grounding plug can result
in a risk of electric shock.
ELECTRICALREQUiREIVIEHTS
The oven is equipped with a 3-prong
grounding
plug. DO
NOT UNDER ANY CIRCUMSTANCES
CUT OR REMOVE
THE GROUNDING
PIN FROM THE PLUG.
DO NOT USE AN EXTENSION
CORD.
The Power Supply Cord and plug must be connected
to
a separate
120 Volt AC, 60 Hz, 15 Amp, or more branch
circuit, single grounded receptacle.
The receptacle
should
be located inside the cabinet directly above the Microwave
Oven mounting location as shown in Figure 2.
HOTE:
1. If you have any questions
about
the grounding
or
electrical
instructions, consult a qualified electrician
or
serviceperson.
2. Neither Electrolux nor the dealer can accept any liability for
damage to the oven or personal injury resulting from failure
to observe the correct electrical connection procedures.
When the hood is vented to the outside, a hood exhaust duct
is required. All ductwork must be metal; absolutely do not use
plastic duct. Check that all connections
are made securely.
Please read the following carefully:
EXHAUSTCONNECTION: T he hood exhaust has been designed
to connect to a standard
3 1/4" x 10" rectangular
duct. If
round duct is required, a rectangular-to-round
adapter must
be used.
REAR EXHAUST: If a rear or horizontal exhaust is to be used,
care should be taken to align the exhaust with the space
between the studs, or wall should be prepared at the time it
is constructed
by leaving enough space between wall studs
to accommodate
exhaust.
MAXIMUM DUCT LENGTH:For satisfactory
air movement, the
total duct length of 3 1/4"x 10" rectangular or 6" diameter round
duct should not exceed 140 feet.
Elbows, adapters, wall caps, roof caps, etc. present additional
resistance to air flow and are equivalent to a section of straight
duct which is longer than their actual physical size. When
calculating the total length, add the equivalent
lengths of all
transitions
and adapters plus the length of all straight duct
sections. Figure 3 shows the approximate feet of equivalent
length of some typical ductwork
parts. Use the values in
parentheses
for calculating
air flow resistance
equivalent,
which should total less than 140 feet.
90° Elbow (10ft.)
90° Elbow (25 ft.)
G
45° Elbow (5 ft.)
45° Elbow (5 ft.)
Adaptor (5 ft.)
Wall cap (40 ft.)
ld' WideElbow (10ft.)
Roof cap (24 ft.)
Figure 3
E2

Hide quick links:

Advertisement

loading

  Also See for Frigidaire FGMV174KFA

  Related Manuals for Frigidaire FGMV174KFA