Specifications; Screwdriver Safety Warnings; Functional Description - Makita 6802bv Instruction Manual

ENGLISH
(Original instructions)
1 Locator
2 Locking sleeve
3 Locking position
4 Gear housing
5 Socket bit

SPECIFICATIONS

Model
Capacities
Self drilling screw ................................................. 6 mm
Bit shank size .................................................... 1/4" Hex
-1
No load speed (min ) ...................................... 0 – 2,500
Overall length ..................................................... 265 mm
Net weight .............................................................. 1.7 kg
Safety class ............................................................
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
Explanation of general view
6 Speed control screw
7 Switch trigger
8 Lock button
9 Low
10 High
6802BV

SCREWDRIVER SAFETY WARNINGS

1.
/II
2.
3.
4.
5.
ENE033-1
SAVE THESE INSTRUCTIONS.
WARNING:
ENF002-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this instruc-
tion manual may cause serious personal injury.

FUNCTIONAL DESCRIPTION

GEA010-1
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Depth adjustment (Fig. 1 & 2)
Pull the locking sleeve forward and then turn it to adjust
the depth. Initially, adjust the locator assembly to create a
distance of approximately 0.5 mm from the tip of the loca-
tor to the tip of the socket bit. One full turn of the locator
equals 1.5 mm change in depth. After adjusting the loca-
tor assembly, push the locking sleeve in to lock the loca-
tor in place. Drive a trial screw into your material or a
piece of duplicate material. If the depth is not suitable for
the screw, continue adjusting until the proper depth set-
ting is obtained.
11 Reversing switch lever
12 Magnetic socket bit
13 Insert bit
14 Magnetic bit holder
Hold power tool by insulated gripping surfaces,
when performing an operation where the fas-
tener may contact hidden wiring or its own cord.
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
Hold the tool firmly.
Keep hands away from rotating parts.
Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
GEB017-4
3