After Starting; Stop/Start System - If Equipped; Automatic Mode - Dodge Durango 2016 Owner's Manual

2. Press the accelerator pedal all the way to the floor and
hold it.
3. Push and release the ENGINE START/STOP button once.
The starter motor will engage automatically, run for
10 seconds, and then disengage. Once this occurs, release
the accelerator pedal and the brake pedal, wait 10 to 15
seconds, then repeat the "Normal Starting" procedure.

After Starting

The idle speed is controlled automatically, and it will
decrease as the engine warms up.
STOP/START SYSTEM — IF EQUIPPED
The Stop/Start function was developed to reduce fuel
consumption. The system will stop the engine automati-
cally during a vehicle stop if the required conditions are
met. Releasing the brake pedal or pressing the accelerator
pedal will automatically re-start the engine.

Automatic Mode

The Stop/Start feature is enabled after every
normal customer engine start. At that time, the
system will go into STOP/START READY and
if all other conditions are met, can go into a
STOP/START AUTOSTOP ACTIVE "Autostop" mode.
To Activate The Autostop Mode, The Following Must
Occur:
• The system must be in STOP/START READY state. A
STOP/START READY message will be displayed in
the Driver Information Display (DID) within the Stop/
Start section. Refer to "Driver Information Display
(DID)" in "Understanding Your Instrument Panel" for
further information.
• The vehicle must be completely stopped.
• The shifter must be in a forward gear and the brake
pedal depressed.
STARTING AND OPERATING 459
5