Instructions For Installation Pages - Venini 60 cm Series User And Installation Instructions Manual

REMOVING THE OVEN DOOR
To facilitate cleaning inside the oven, the door can be removed as follows:
1) Ovens mounting hinges with movable bolts (as per Fig. 1): The hinges are provided with two
movable bolts (B). When the bolt is raised, the hinge (A) can be released from its housing.
2) Hold the door on each side, then lift to unhook the hinge mechanism and pull outwards to
release from the oven. Grip the sides of the door near the hinges when performing these
operations.
3) To refit, hold the door in the fully open position and slide the hinge arms (A) into the oven
recesses until the arms lock in position. On models with hinge mechanisms as per Fig.1,
rotate the two movable bolts (B) and close the door fully to complete the refitting.
WARNING

Take care not to dislodge the hinge lock system when removing the door as the hinge
mechanism has a strong spring system!

Do not immerse the door in water at any time.
Fig.1
INSTRUCTIONS FOR INSTALLATION
This appliance must be installed by a competent person, in accordance with the current version of
the following UK Regulations and Safety Standards or your local Regulations and Safety
Standards:
Building Regulations (issued by the Department of Environment)
Building Standards (issued by the Scottish Development Department)
IEE Wiring Regulations
Electricity at Work Regulations
In Australia the installation must comply with AS/NZS3000 wiring rules
9