Figure 2.32 Importing The Encryption Key - Fujitsu ETERNUS LT260 User Manual

Chapter 2 Setup and Operation Procedures
2.1 Basic Setup
2.1.4.2 Importing the Encryption Key
• To use an encrypted data cartridge brought in from outside in the LT260 with a different master key,
import the encryption key for that data cartridge before mounting in the LT260. If the encryption key was
not imported, data writing is not allowed.
• If the encrypted data cartridge brought in from the outside is mounted in the LT260 with a different mas-
ter key before the encryption key has been imported, a new encryption key may be assigned to the data
cartridge. The new encryption key can be overwritten by importing the encryption key that was exported
in advance.
Procedure
1
Move to the [Configuration > Encryption > LT Encryption] screen.
2
Select [Encryption Keys] > [Import Key] on the center pane.
3
Select the encryption key file that is to be imported.
4
Select the partition where the encryption key is to be imported.
If no logical libraries (or partitions) are configured, only "Partition_1" is displayed in the drop down
list.
5
Enter the password that was set when the encryption key was exported.
For details about the password, refer to
6
Click [Submit].

Figure 2.32 Importing the encryption key

FUJITSU Storage ETERNUS LT260 Tape Library Key Management Function Option User's Guide
"2.1.4.1 Exporting the Encryption Key" (page
50
Copyright 2016 FUJITSU LIMITED
43).
P3AG-1192-02ENZ0