5-21) Icemaker Thermistor; 5-22) Auger Motor Case - Samsung RS2530B Service Manual

DISASSEMBLY AND REASSEMBLY
5-20) ICE MAKER KIT
Part name
The ice maker is located inside of the
ice dispenser assembly.1.
Remove ice maker support screws
(2), and slide out.
2. Disconnect the ice maker wire
connector.
3. Unlock the locking tabs to separate
the ice maker kit.
Ice Dispenser
& Ice Maker
In order to assemble the icemaker kit.
1. Assemble the geared motor shaft
and the front of ice tray.
2. Lift the front locking tab and
assemble the ice maker kit.
3. Connect the ice maker wire connector.
4. Match the tab holes and tabs(2)
located on the top of the liner, and
slide the ice maker in.
5. Tighten the screws (2) of the ice
maker support.

5-21) ICEMAKER THERMISTOR

Part name
The Ice-Maker thermistor is located in its bottom.
The temperature signal sends the micro-
processor.
Ice-Maker
Thermistor

5-22) AUGER MOTOR CASE

Part name
This shelf is designed to support the ice maker &
ice dispensed and Xtra Space
1. Remove the Xtra Space
down and pull front.
Auger Motor
2. Slide the partition out.
Case
3. Remove the screws (2) on the bottom front of
the case.
4. Slide out the case while disconnecting the wire
connect.
Descriptive Picture
Descriptive Picture
Descriptive Picture
TM .
TM cover to push it
How To Do
WIRE CONNECTOR
FRONT LOCKING TAB
FRONT OF ICE TRAY
GEARED MOTOR SHAFT
43
SUPPORT OF ICE-MAKER
LOCKING TAB
ICE-MAKER KIT
TAB HOLES
How To Do
Thermistor ( ICE-MAKER )
How To Do
Partition
Screws