What If There Are Problems; Replacement Parts; Lw 110 Technical Data - Beurer LW 110 Instructions For Use Manual

Hide thumbs Also See for LW 110:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
Clean the water level sensor
You can clean the lower half of the water level sensor in a cleaning bath. Ensure that the upper half of the
water level sensor is not exposed to any harsh cleaning products. The water level sensor must not be cleaned
in the dishwasher.
Descaling the humidification discs and the tub
Depending on water hardness and if necessary, the tub and humidification discs must be descaled in order
to maintain the performance of the air washer.
For this purpose, use a standard descaling agent and observe the information on the label.
Note: A light build-up of limescale on the humidification discs increases the evaporation effect.
Storage
If you do not plan to use the device for a relatively long period of time, we recommend that you thoroughly
empty, clean and dry the device and store it in the original packing in a dry environment, ensuring it is not
weighed down by additional items.

8. What if there are problems?

Problem
No display.
No display.
The upper cover cannot be
fitted precisely.
The water level gauge
always shows the same fill
level despite differing water
levels.

9. Replacement parts

Only use original parts and from the manufacturer.

10. LW 110 technical data

Dimensions (L x W x H)
Cable length
Weight when empty
Power supply unit.
Output
Suitable for rooms
Maximum capacity
Cause
The device is not connected to
mains power supply.
The device has switched itself off
due to safety reasons.
The guide rails do not fit and the
upper cover is jammed.
The fill level sensor is dirty.
30 x 30 x 34 cm
approx. 2 m
approx. 6 kg
220 – 240 Volt/50 – 60 Hz
38 Watt
up to approx. 36 m²
approx. 7.25 litres
Solution
Connect the mains plug and switch on
the device.
Clean and refill the device before next
use. Then switch it on again.
Turn the upper cover around by 180°
and reposition it on the tub.
Remove the upper cover from the tub,
unlock the water level sensor, remove
it and clean carefully.
16

Advertisement

Table of Contents
loading

Table of Contents