Manual Registration; Repeating Registration - Gigaset A31008-M601-R101-4-SU19 Operating Instructions Manual

Preparing

Manual registration

Carry out the following steps:
Ensure that other base stations close to the Gigaset Repeater are not in registration mode during
this process.
The Gigaset Repeater can be registered independently of the length of an audible registra-
tion tone or a display at the base station.
If registration is not successful, the LED on the Gigaset Repeater will flash continuously. In
this case, repeat the procedure.

Repeating registration

You can reregister the Gigaset Repeater at any time, for example if initial registration was unsuccessful, or
if the Gigaset Repeater is to be registered at another base station for the first time.
Before registering the Gigaset Repeater once again (e.g. at a different base station), please reset the Gigaset
Repeater beforehand as described below:
Switch on the unit (power plug inserted)
●
$
Press the registration button for at least 10 seconds to reset
●
The Gigaset Repeater is now ready to be registered again as described above. This is signalled by the LED
which flashes continually once the power plug is reconnected.
18
Gigaset Repeater is enabled (power plug inserted).
$
Place the base station in Repeater registration mode in the
same way as you would to manually register a handset.
Please refer to the operating instructions for your base sta-
tion.
To perform manual registration, press the registration button
for 4 seconds (it can be found on the rear of the device, see
figure above).
Enter the number of the repeater (talk button, choose be-
tween 2 - 7) on any (registered) handset and then press the
hash key.
If you are registering a number of repeaters at your base sta-
tion, make sure to assign them different numbers.
The left LED on the Gigaset Repeater flashes continually. Af-
ter a short while the LED stays on permanently indicating
that registration is complete and that the unit is ready for op-
eration.