Table of Contents
Advertisement
Installation
Once you have registered your Gigaset Repeater you can install it wherever you would like to extend the
reception range of your handsets. However, you must ensure that there is a power point at the place of
installation and that the left LED remains on constantly after the device has been switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or reception is being hin-
dered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a good connection
with the base station at the Gigaset Repeater installation site.
To operate a handset for the first time in the extended Gigaset Repeater area, switch off the handset within
the new reception range of the Gigaset Repeater, but outside the reception range of the base station and
then switch it back on again:
If you are using more than one Gigaset Repeater in the area of your base station, you must keep
the Gigaset Repeaters at least 10m apart.
LED display of functions
There are two green LEDs on the centre front of the housing. The left LED displays registration and opera-
tion function, the right LED displays the handset-traffic via this repeater:
Left LED states:
Dark
Flashing
Continuous lighting
Intermittent flashing
Fast flashing
Right LED states:
Dark
Flashing once
Flashing twice
Base station
power supply off
no link to base station
normal link to base station
ready to register
manual registration: the repeater waits for input on the handset
no traffic
one handset link via repeater
two handset link via repeater
Extended reception area
Preparing
19
Advertisement
Table of Contents
