Table of Contents
Advertisement
Miscellaneous
Using the verification tone
The verification tone enables you to establish whether or not the handset is working in the extended area
of the Gigaset Repeater. This tone is audible on the activated handset as long as the unit is connected to
the Gigaset Repeater.
Carry out the procedure described below on your Gigaset Repeater in order to switch the verification tone
on and off:
Switch on the unit (power plug inserted)
●
$
Press the registration button for at least 20 seconds to switch on/off
●
Miscellaneous
Troubleshooting
Problem
Left LED flashes continuously
when the registration procedure
has been concluded
Left LED flashes continuously at a
selected location
Left LED does not light up at all
No reception of the handset in
the area of the repeater
Technical data
Standards:
Radio frequency range:
Transmit power:
Range:
Power supply:
Power consumption:
Operating temperature:
Dimensions (mm):
Weight:
Power cable length:
20
Cause
No radio connection to the
base station
No radio connection to the
base station
No power
Repeater not registered
No radio connection to the
base station
Handset cannot find the
repeater
Compatible to DECT, GAP
1880 MHz - 1900 MHz
10 mW average power per channel
max. 300 m outdoors,
max. 50 m indoors
220/230 V, 50 Hz (plug-in power unit)
6 VA
-10 °C to + 45°C
131 x 111 x 50 (LxBxH)
136 g
approx. 3 m
Action
Repeat registration
Select a new location
Check the power point
Repeat registration
Select a new location
Switch handset on and off
Advertisement
Table of Contents
