Table of Contents
Advertisement
Socket
for
power
lead
LED's
Preparing
Please refer to the user guide for your phone to check whether your base station is suitable for operating
the repeater and how to prepare it for registering the repeater.
If a repeater can't register at your base station, make sure repeater mode is enabled.
Automatic registration
Carry out the following steps:
Manual registration
Carry out the following steps:
Registration button
The power lead supplied is plugged into the socket on the Gigaset
Repeater's rear side.
The different operating modes are indicated on the front of the
Repeater unit by means of two LED's (for an explanation, see
page 17).
Gigaset Repeater is enabled (power plug inserted). The de-
$
vice is then in registration mode for a period of five minutes.
Place the base station in Repeater registration mode in the
same way as you would to manually register a handset. Ple-
ase refer to the operating instructions for your base station.
Gigaset Repeater is enabled (power plug inserted).
$
Place the base station in Repeater registration mode in the
same way as you would to manually register a handset. Ple-
ase refer to the operating instructions for your base station.
To perform manual registration, press the registration button
for 4 seconds (it can be found on the rear of the device, see
figure above).
Enter the number of the repeater (talk button, choose bet-
ween 2 - 7) on any (registered) handset and then press the
hash key.
If you are registering a number of repeaters at your base sta-
tion, make sure to assign them different numbers.
Preparing
15
Advertisement
Table of Contents
