Table of Contents
Advertisement
Installation
Repeating registration
You can reregister the Gigaset Repeater at any time, for example if initial registration was unsuccessful, or
if the Gigaset Repeater is to be registered at another base station for the first time.
Before registering the Gigaset Repeater once again (e.g. at a different base station), please reset the Gigaset
Repeater beforehand as described below:
Switch off the unit (disconnect the power plug)
●
$
Switch on for 1 to 5 seconds and switch it off again
●
$
Switch on for 25 to 35 seconds and switch it off again.
●
$
The Gigaset Repeater is now ready to be registered again as described above. This is signalled by the LED
which flashes continually once the power plug is reconnected.
Installation
Once you have registered your Gigaset Repeater you can install it wherever you would like to extend the
reception range of your handsets. However, you must ensure that there is a power point at the place of
installation and that the left LED remains on constantly after the device has been switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or reception is being hin-
dered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a good connection
with the base station at the Gigaset Repeater installation site.
To operate a handset for the first time in the extended Gigaset Repeater area, switch off the handset within
the new reception range of the Gigaset Repeater, but outside the reception range of the base station and
then switch it back on again:
If you are using more than one Gigaset Repeater in the area of your base station, you must keep
the Gigaset Repeaters at least 10m apart.
16
Base station
Extended reception area
Advertisement
Table of Contents
