En Opening An Incoming Message; Ther . Functions; Speed Dial Buttons - JabloCom GDP-04i User Manual

For entering special symbols shown above the top line of the QWERTY keys (#, $, %, &, etc.), press
gether with a key from the top line of the QWERTY character keys. To enter a phone number from the phonebook into
the text message, press
For entering other specific symbols or characters like Ü, Ö, Å, §, etc., open the entire symbol character table by pres-
sing key for about 2 seconds. Select the desired symbol and press the Insert selection key to place it into the
text. You can move fast through the table by pressing the corresponding base character (U, O, A).
If your phone firmware supports specific languages like Russian or Arabic, its keyboard is switched
into the respective alphabet layout after choosing the language. You can switch between it and the
Latin alphabet by pressing
Opening an incoming message
When a new text message is received, it is confirmed by an acoustic
signal as well as the flashing of the red indicator light on the top right
hand side of the phone. The envelope symbol
display.
EN
Press to read the received text message and scroll
through the message by using
Additional functions, listed below, can be performed by activating the o
below the LCD:
D
elete
r
ePly
F
orwarD
c
all
D
etails
n ...
ew
s
tore number
D
elete all
To read previous incoming messages or to send messages, open the m
i or s .
nbox ent
Other functions

Speed dial buttons

There are six buttons on your GDP-04i that can be used for frequently
called numbers or emergency numbers.
To enter a new number, hold down the selected memory button for
about two seconds until the P
phone number and press oK selection key.
To connect a speed dial button with a contact from your phonebook, find
the contact name in your phonebook and press and hold the selected
speed dial button for about 2 seconds until you see the confirmation on
the display.
Another 6 memories are available when you use dial button with the
If you want to enter a DTMF command only, it must be iniciated by a "P" character. Example: P*2121481#.
GDP-04.i.ENG.MAN.User_Manual.15.B
button, find the desired contact and select the number to enter.
button +
will appear on the
.
– deletes the current text message
– sends a reply to the message sender
– forwards the message to another recipient
– calls back the message sender
– shows detail information about message sender and time
– starts a new text message
– saves the message sender's number in your phone book
– deletes all messages in the current folder
: dialog appears. Enter the
hone number
button together.
menu by pressing the selection key
Ptions
menu by pressing
essages
key.
- 6 -
key to-
and select