Haier HW-07LN03 Service Manual page 24

Take out the conditioner and accessories
3.
from the package .
Lift the back of the machine body slightly.
4.
You can see the drain hole at the back of
the bottom plate. Plug the black rubber lid
of the enclosed accessories into the hole.
(see Fig. 5).
Plug the drain elbow of the enclosed
5.
accessories (with seal ring) into the drain
hole on the vertical wall at the back of the
bottom plate (see Fig. 6)
If you need to lead the condensed water
6.
to indicated position, please purchase a
piece of plastic pipe with inner diameter
of Φ 16, set it on the drain elbow and tie it
tightly.
After installation of all the accessories,
7.
put the whole machine on the iron frame.
If there's extra pipe, lead the pipe to
needed position (see Fig7).
Fill any distance between the wall hole
8.
and the machine body with flexible sponge
rubber strip to prevent the entering of outer
noise and the leaking of the coolness.
After installation of the conditioner, insert
9.
the power plug into the outlet and perform
test-run.
Haier air conditioner
- 24 -
Edition: 20070925
Fig. 5
Fig. 6
Fig. 7